Change System Controlled to Operator Controlled Mode by code

Discussions about CSEntry
Post Reply
hannesrr
Posts: 41
Joined: January 8th, 2013, 5:02 pm

Change System Controlled to Operator Controlled Mode by code

Post by hannesrr » January 24th, 2013, 7:21 pm

Hello everybody:

Somebody could tell me, how can I Change System Controlled to Operator Controlled Mode by code?...

Thank you. :geek:
Hannes Rodriguez :geek:

Gregory Martin
Posts: 1347
Joined: December 5th, 2011, 11:27 pm
Location: Washington, DC

Re: Change System Controlled to Operator Controlled Mode by

Post by Gregory Martin » January 28th, 2013, 5:19 pm

set path on; // turns on sytem controlled mode

set path off; // turns on operator controlled mode
This is a compile-time setting though. That means that you can't switch from system to operator controlled modes while the program is running.

hannesrr
Posts: 41
Joined: January 8th, 2013, 5:02 pm

Re: Change System Controlled to Operator Controlled Mode by

Post by hannesrr » January 29th, 2013, 11:05 am

Thank you Gregory.
Hannes Rodriguez :geek:

Post Reply