Using the onkey Function to view arrays
Posted: November 4th, 2019, 7:09 pm
Hello everyone,
I would like to consult them if it is possible through the onkey function to show the user the contents of an array. As an example, the questionnaire has 10 sections and the array to be shown was defined after the end of section 5.
Thus, if the user uses the onkey function it should not be activated until section 5, ie it should only be activated in sections 6 to 10.
Thank you!
I would like to consult them if it is possible through the onkey function to show the user the contents of an array. As an example, the questionnaire has 10 sections and the array to be shown was defined after the end of section 5.
Thus, if the user uses the onkey function it should not be activated until section 5, ie it should only be activated in sections 6 to 10.
Thank you!