Modify Mode Gives and error

[munirmdee1]

Hi CSPro Users,

I have a CSPro 7.5 Application, when I run it for Add mode its working fine, but when I open in Modify mode its gives me an error and when I click OK twice it continues.
Im getting the following error message"

"The case specified for modifying, was not located in the data file"

Whats the reasons for this?

[aaronw]

When modifying a case you must specify the case. It's likely you're not or the case does not exist. There's a couple ways to do this. In CSPro 7.5 you can use the key property. Otherwise, you can write the startmode like StartMode=Modify;010502. See the helps for more information:
https://www.csprousers.org/help/CSPro/r ... entry.html