I have a strange issue. Seems like a bug. version is 7.6.2
It's multi answer question. So, I apply values on the fly into binary variables as below. it works ok unless this variable was skipped. The issue is I have strange values in some cases after the whole section was skipped. Cases were completed and closed properly. See the screenshot from the attachment.
Does anyone have any idea?
Code: Select all
PROC C11
postproc
if length(strip($))=0 then
reenter;
endif;
if pos("A", $) > 0 then C11_1=1; else C11_1=2; endif;
if pos("B", $) > 0 then C11_2=1; else C11_2=2; endif;
if pos("C", $) > 0 then C11_3=1; else C11_3=2; endif;
if pos("D", $) > 0 then C11_4=1; else C11_4=2; endif;