Hi CSPro Users,
I have a CSPro 7.5 Application, when I run it for Add mode its working fine, but when I open in Modify mode its gives me an error and when I click OK twice it continues.
Im getting the following error message"
"The case specified for modifying, was not located in the data file"
Whats the reasons for this?
Modify Mode Gives and error
Forum rules
New release: CSPro 8.0
New release: CSPro 8.0
-
- Posts: 74
- Joined: August 17th, 2015, 9:32 am
- Location: Dar es Salaam, Tanzania
Modify Mode Gives and error
Munir Mdee
Software Programmer
National Bureau of Statistic (NBS)
Jakaya Kikwete Road,
P.O.Box 2683,
Dodoma,TANZANIA
Mob: +255 755 740090
Email: munir.mdee@nbs.go.tz
munirmdee@gmail.com
Software Programmer
National Bureau of Statistic (NBS)
Jakaya Kikwete Road,
P.O.Box 2683,
Dodoma,TANZANIA
Mob: +255 755 740090
Email: munir.mdee@nbs.go.tz
munirmdee@gmail.com
Re: Modify Mode Gives and error
When modifying a case you must specify the case. It's likely you're not or the case does not exist. There's a couple ways to do this. In CSPro 7.5 you can use the key property. Otherwise, you can write the startmode like StartMode=Modify;010502. See the helps for more information:
https://www.csprousers.org/help/CSPro/r ... entry.html
https://www.csprousers.org/help/CSPro/r ... entry.html